This article discusses Foundries.io's microPlatforms which support Intel, Arm, and RISC-V architectures and are designed to avoid lock-in to specific hardware implementations.
March 28, 2019 by Trina Watt, Foundries.io
This article explores how RISC-V, combined with open-source collaboration and standards, is enabling innovation and purpose-built technologies among software engineers, system architects, CTOs, and board designers. It also touches on the possible impact that RISC-V and open source trends could have on the future of data-centric application experiences.
March 20, 2019 by Ted Marena, Western Digital
This article reviews the fundamental features of an effective protection scheme, highlights the shortcoming of a typical protection implementation—such as a high bill of materials and PC board size occupation—and introduces a new family of integrated, highly flexible protection ICs that address these concerns.
June 05, 2018 by Maxim Integrated
SoCs with programmable logic are an essential element of real-time embedded vision systems. Designers can capitalize on the power and efficiency of Xilinx's Zynq Ultrascale+ MPSoC devices to implement their designs using Avnet's Embedded Vision Kits and the Xilinx reVISION stack.
May 18, 2018 by Xilinx
Systems that incorporate highly integrated and highly sophisticated, high power radio frequency (RF) GaN power amplifiers (PAs), such as pulsed radar applications, are a constant challenge for today’s digital control and management systems to keep up with these ever-increasing levels of sophistication.
November 21, 2017 by Analog Dialogue
This article introduces Severe Environment Testing (SET), a safety testing standard that bridges the gap between a full MIL-STD product and a COTS product to provide additional confidence in the safety of a COTS product.
November 19, 2019 by Brian Niehoff, Samtec
This article describes a methodology that automates set up, constraints, and results analysis as designs move from static CDC analysis to formal verification to simulation and avoid manual scripting efforts, thus reducing setup effort and errors.
November 14, 2019 by Kurt Takara, Mentor
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
This article looks at the safety standard that governs ADAS features and the challenge in designing power monitoring systems to comply with this standard while introducing an automotive power monitor that has been certified to meet this standard.
September 06, 2019 by Michael Jackson, Maxim Integrated
Power system designers are constantly under pressure because they are tasked with developing highly adaptive solutions that comply with today’s operating environments without interrupting design-to-manufacture cycles.
June 28, 2019 by MINMAX
Novel approaches to end node power supply design using switched-mode converters can enable a wireless end node to operate from a CR2032 lithium coin cell with up to +20 dBm transmit power.
June 25, 2019 by Josh Norem, Silicon Labs