In the systems where custom sensors are required, it's imperative that the designer quantifies the environmental, mechanical, electrical, and magnetic parameters of the entire system so that a sensor which meets those operating conditions can be selected.
January 14, 2016 by Gwenn Gmeinder, Littelfuse
This app note implements a binary parity generator and checker with two data input variants, a parallel data input, and a serial data input. It describes the implemented logic, GreenPAKs implementation, and the obtained results.
June 12, 2018 by Dialog Semiconductor
This article shows how to implement an analog PID controller, including adjusting of the angular position of a DC motor shaft, editing the design to control its speed, and tuning PID parameters for reliable performance.
August 14, 2018 by Mahmoud Hamdy, Brightskies Technologies
This 12-part “Resolving the Signal” series aims to provide a comprehensive understanding of noise in delta-sigma ADCs. In part 1 of this series, I’ll focus on ADC noise fundamentals.
January 23, 2018 by Bryan Lizon, Texas Instruments
In part 2 of this series, I'll continue the fundamental ADC noise discussion by covering how to measure ADC noise, noise specifications in ADC data sheets, and absolute versus relative noise parameters.
February 13, 2018 by Bryan Lizon, Texas Instruments