Win a SAM E54 Xplained Pro Evaluation Kit from Microchip!

Giveaway Overview:

Enter for a chance to win a SAM E54 Xplained Pro Evaluation Kit from our giveaway partner Microchip!

The SAM E54 Xplained Pro evaluation kit is a hardware platform for evaluating the ATSAME54P20A microcontroller (MCU). Supported by the Studio integrated development platform, the kit provides easy access to the features of the ATSAME54P20A and explains how to integrate the device into a custom design.

For more information on the SAM E54 Xplained Pro Evaluation Kit, visit Microchip. 

Kit Features:

1. ATSAME54P20A microcontroller
2. Embedded Debugger - USB interface. Auto-ID for board identification in Atmel Studio. One yellow status LED. One green board power LED. Symbolic debug of complex data types including scope information. Programming and debugging of on-board SAME54 through Serial Wire Debug (SWD). Data Gateway Interface: SPI, I2C, four GPIOs. Virtual COM port (CDC). Embedded current measurement circuitry (XAM).
3. Digital I/O - Two mechanical buttons (user and reset button). One Atmel QTouch button. One yellow user LED. Three Xplained Pro extension headers.
4. 256Mb QSPI Flash
5. ATECC508 CryptoAuthenticationTM device
6. AT24MAC402 serial EEPROM with EUI-48TM MAC address
7. Ethernet - RJ45 connector with built-in magnetics, KSZ8091RNA PHY, 10Base-T/100Base-TX IEEE 802.3 compliant Ethernet tranceiver
8. SD/SDIO card connector
9. Parallell Capture Controller header (ArduCAM compatible)
10. ATA6561 CAN transceiver
11. Backup SuperCapacitor
12. 32.768kHz & 12MHz crystal
13. Debug connectors - 10-pin Cortex Debug Connector with SWD, 20-pin Cortex Debug + ETM Connector with four bit trace.
14. Supported with application examples in Atmel START

Register Below to Enter Giveaway