This article discusses how the use of three key design methods utilized in optocouplers improves galvanic isolation performance and presents an accompanying high voltage surge test as proof.
January 14, 2020 by Lim Shiun Pi, Broadcom Inc
In this article, we discuss some key security threats to be aware of when designing for the IoT, important security functions, and how protecting these designs is becoming easier with advances in security ICs.
4 days ago by Scott Jones, Maxim Integrated
In this article, learn how to enable I2C by allowing the LPC55S69 MCU on the E1 board to communicate with a Bosch BME280 environmental sensor present on the Microe Weather click module.
September 10, 2020 by Mark Dunnett, on Behalf of NXP
Floating-gate Flash circuitry is only embedded in devices fabricated at 40nm or earlier nodes, so it is not embedded in the most advanced, highest-performance processors. For secure code and data storage, designers, therefore, have to specify an external device that contains secure memory capacity.
In partnership with Winbond
What are your assumptions about the reliability, longevity, and performance of NAND? This article proposes that embedded developers should open their minds to the potential benefits of replacing SPI NOR Flash with serial NAND Flash for storing mission-critical boot and application code.
In partnership with Winbond
MCAD and ECAD have inserted themselves into most design engineers' day-to-day work. Although familiar, both programs have come a long way and are continuing to evolve. In this article, learn the past and future of these design tools.
August 27, 2020 by Sam Sattel, Autodesk
Intel Enpirion PowerSoC modules are DC-DC step-down converters that integrate nearly all the components needed to build a power supply without sacrificing performance or efficiency. These solutions are designed to meet strict FPGA, ASIC, and processor power requirements.
August 25, 2020 by Tamara Lin, Intel
The OKdo E1 development board is only as wide as a coin but contains the LPC55S69 microcontroller, making it suitable for a variety of small production runs and prototypes. Here, get more familiar with the dev board and see how to use its evaluation kit.
August 20, 2020 by Mark Dunnett, on Behalf of NXP
Autonomous drones and robots utilize small motors. These fast-spinning mini motors require miniature encoders and IC package sizes. This article shows how an optical sinusoidal encoder provides a higher resolution and increased speeds with a 2x3 mm dual simultaneous-sampling SAR-ADC.
August 11, 2020 by Bonnie Baker, Maxim Integrated
Explore the LPC55S16, an MCU well-suited for industrial and professional applications, thanks to its fast clock speed of 150 MHz, out-of-the-box support for communicating over a CAN-FD bus network, and low current consumption.
August 06, 2020 by Mark Dunnett, on Behalf of NXP
The FixturFab DEV260 development fixture allows designers to debug or configure PCBAs during the development phase. See how it works in this example using the Sparkfun Power Delivery Board.
August 04, 2020 by Duncan Lowder, FixturFab
As automotive moves from domain to zonal networks, many different kinds of data end up sharing the same wires. This article looks at IEEE 802.1’s Time-Sensitive Networking (TSN) standards as a solution.
July 21, 2020 by Don Pannell, NXP Semiconductors
Intermediate Bus Architecture is an emerging method that power designers are using to conserve PCB space. This article discusses the solution benefits and tradeoffs of adopting this technique, and how it may be scaled to address application-specific requirements.
July 07, 2020 by Tamara Lin, Intel
