This design solution evaluates the accuracy of thermocouples used for high-temperature measurements as well as resistance temperature detectors (RTDs) used for local cold-junction-compensation (CJC) points.
April 11, 2019 by Bonnie Baker, Maxim Integrated
With the introduction of a new set of requirements by the US Department of Energy that became law in February 2016, it has become mandatory for manufacturers to improve the efficiency of old designs to meet DoE Level VI in order to sell them to the US market.
July 11, 2017 by Zhihong Yu, Monolithic Power Systems
This article introduces Severe Environment Testing (SET), a safety testing standard that bridges the gap between a full MIL-STD product and a COTS product to provide additional confidence in the safety of a COTS product.
November 19, 2019 by Brian Niehoff, Samtec
This article describes a methodology that automates set up, constraints, and results analysis as designs move from static CDC analysis to formal verification to simulation and avoid manual scripting efforts, thus reducing setup effort and errors.
November 14, 2019 by Kurt Takara, Mentor
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
This article looks at the safety standard that governs ADAS features and the challenge in designing power monitoring systems to comply with this standard while introducing an automotive power monitor that has been certified to meet this standard.
September 06, 2019 by Michael Jackson, Maxim Integrated
Power system designers are constantly under pressure because they are tasked with developing highly adaptive solutions that comply with today’s operating environments without interrupting design-to-manufacture cycles.
June 28, 2019 by MINMAX
Novel approaches to end node power supply design using switched-mode converters can enable a wireless end node to operate from a CR2032 lithium coin cell with up to +20 dBm transmit power.
June 25, 2019 by Josh Norem, Silicon Labs