This article outlines traditional half-duplex RS-485 configurations and then presents new alternatives for simplifying the control interface by eliminating the required control lines and software control code.
May 29, 2018 by Bonnie Baker, Maxim Integrated
Connected industrial machines can sense a wide array of information used to make key decisions within the Industrial Internet of Things (IIoT). A sensor within an edge node can be spatially far removed from any data aggregation point. It must connect through a gateway that links edge data with a network.
January 09, 2018 by Ian Beavers, Analog Devices
The industrial Internet of Things (IoT) encompasses the broad transformation underway that will make pervasive sensing across connected machines not just a competitive advantage, but an essential fundamental service. The industrial IoT starts with the edge node, which is the sensing and measurement entry point of interest.
September 12, 2017 by Ian Beavers, Analog Devices
Digital power supplies are widely employed in high-end servers, storage, telecom brick modules, and more. For these applications, isolation is often required. This article discusses the digital isolation techniques with Analog Devices’ iCoupler products in digital power supply design.
August 01, 2017 by Jason Duan, Analog Devices
Development is well underway on Gigabit LTE cellular communications systems that promise an order of magnitude increase in data transfer rates and 5G is close behind. Small cell access nodes will form an essential part of both systems but new communications processors are needed to make these a reality.
June 08, 2017 by Emmanuel Gresset, CEVA
Passive intermodulation represents the intermodulation products generated when two or more signals transit through a passive device with nonlinear properties. The interaction of mechanical components generally causes nonlinear elements.
May 09, 2017 by Frank Kearney, Analog Devices