Connected industrial machines can sense a wide array of information used to make key decisions within the Industrial Internet of Things (IIoT). A sensor within an edge node can be spatially far removed from any data aggregation point. It must connect through a gateway that links edge data with a network.
January 09, 2018 by Ian Beavers, Analog Devices
Integrated RF agile transceivers are not only widely employed in software-defined radio (SDR) architectures in cellular telephone base stations, such as multiservice distributed access system (MDAS) and small cell, but also for wireless HD video transmission for industrial, commercial, and military applications, such as unmanned aerial vehicles (UAVs).
November 07, 2017 by Wei Zhou, Analog Devices
In this multipart industrial IoT series, we will break down and explore the fundamental aspects of the edge node interpretation within the larger IoT framework: sensing, measuring, interpreting, and connecting data, with additional consideration for power management and security.
September 26, 2017 by Ian Beavers, Analog Devices
This article introduces Severe Environment Testing (SET), a safety testing standard that bridges the gap between a full MIL-STD product and a COTS product to provide additional confidence in the safety of a COTS product.
November 19, 2019 by Brian Niehoff, Samtec
This article describes a methodology that automates set up, constraints, and results analysis as designs move from static CDC analysis to formal verification to simulation and avoid manual scripting efforts, thus reducing setup effort and errors.
November 14, 2019 by Kurt Takara, Mentor
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
This article looks at the safety standard that governs ADAS features and the challenge in designing power monitoring systems to comply with this standard while introducing an automotive power monitor that has been certified to meet this standard.
September 06, 2019 by Michael Jackson, Maxim Integrated
Power system designers are constantly under pressure because they are tasked with developing highly adaptive solutions that comply with today’s operating environments without interrupting design-to-manufacture cycles.
June 28, 2019 by MINMAX
Novel approaches to end node power supply design using switched-mode converters can enable a wireless end node to operate from a CR2032 lithium coin cell with up to +20 dBm transmit power.
June 25, 2019 by Josh Norem, Silicon Labs