3GPP Release 16 holds the promise to make high precision location services cheaper and more reliable. Exploiting new signal properties in combination with a variety of non-cellular technologies could enable forms of hybrid positioning.
April 02, 2019 by Sylvia Lu, u-blox
The Bel Fuse 0AD family of fuses are small fuses with very high AC and DC voltage ratings and interrupting ratings. The fuses leverage advanced materials and processing to shrink the fuse size without sacrificing electrical performance or physical integrity.
February 01, 2019 by Bel Fuse
This article looks at a solution to add additional USB charging ports to a vehicle using a single chip containing all the necessary parts and delivers 5V to the device.
July 10, 2018 by Nazzareno Rossetti, Maxim Integrated
This article reviews the fundamental features of an effective protection scheme, highlights the shortcoming of a typical protection implementation—such as a high bill of materials and PC board size occupation—and introduces a new family of integrated, highly flexible protection ICs that address these concerns.
June 05, 2018 by Maxim Integrated
This 12-part “Resolving the Signal” series aims to provide a comprehensive understanding of noise in delta-sigma ADCs. In part 1 of this series, I’ll focus on ADC noise fundamentals.
January 23, 2018 by Bryan Lizon, Texas Instruments
Part 1 of this two-part series discusses the key parameters and features a designer needs to be aware of and how they relate to inclination and stabilization applications, thus helping the designer choose the most suitable accelerometer.
December 12, 2017 by Chris Murphy, Analog Devices
There is a trend beginning for a whole new network of smart devices to listen and respond to requests for all rooms of your smart home so you don't have to hear "I'm sorry, I didn't get that" anymore.
October 10, 2017 by Morgan Lollar, Texas Instruments
Critical to the success of any product is its user experience. From household appliances through to websites, the ones that succeed are both functional and easy–or even enjoyable–to use.
July 18, 2017 by Scott Soong, Pervasive Displays
This article introduces Severe Environment Testing (SET), a safety testing standard that bridges the gap between a full MIL-STD product and a COTS product to provide additional confidence in the safety of a COTS product.
November 19, 2019 by Brian Niehoff, Samtec
This article describes a methodology that automates set up, constraints, and results analysis as designs move from static CDC analysis to formal verification to simulation and avoid manual scripting efforts, thus reducing setup effort and errors.
November 14, 2019 by Kurt Takara, Mentor
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
This article looks at the safety standard that governs ADAS features and the challenge in designing power monitoring systems to comply with this standard while introducing an automotive power monitor that has been certified to meet this standard.
September 06, 2019 by Michael Jackson, Maxim Integrated
Power system designers are constantly under pressure because they are tasked with developing highly adaptive solutions that comply with today’s operating environments without interrupting design-to-manufacture cycles.
June 28, 2019 by MINMAX
Novel approaches to end node power supply design using switched-mode converters can enable a wireless end node to operate from a CR2032 lithium coin cell with up to +20 dBm transmit power.
June 25, 2019 by Josh Norem, Silicon Labs