This article explores using PSpice for TI to simulate potential causes for parasitic effects in a motor-drive design and offers design tips to mitigate the negative effects common with high-power motor-drive systems.
February 04, 2021 by Matt Hein, Texas Instruments
This article looks at semiconductor technologies that are driving EV chargers, including high-voltage semiconductor switches, power converters, and multi-level complex power stages.
October 06, 2020 by Jayanth Rangaraju, Texas Instruments
Autonomous drones and robots utilize small motors. These fast-spinning mini motors require miniature encoders and IC package sizes. This article shows how an optical sinusoidal encoder provides a higher resolution and increased speeds with a 2x3 mm dual simultaneous-sampling SAR-ADC.
August 11, 2020 by Bonnie Baker, Maxim Integrated
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
In part 12 of Resolving the Signal, we look at a power-supply noise design example to discuss which supplies are most critical when trying to increase a system's PSR. From that example, we offer best practices to maintain low power-supply noise and debugging tips for a system's overall noise performance.
January 29, 2019 by Bryan Lizon, Texas Instruments
Part 11 of the Resolving the Signal series explores how power supplies contribute to unwanted noise, how to measure and quantify that noise, and how noise ends up impacting system performance.
December 11, 2018 by Bryan Lizon, Texas Instruments
Part 8 of the Resolving the Signal series dives further into how different noise sources impact precision delta-sigma ADCs by focusing on reference noise and ADC noise, and how gain affects reference noise.
August 21, 2018 by Bryan Lizon, Texas Instruments
This article shows how to implement an analog PID controller, including adjusting of the angular position of a DC motor shaft, editing the design to control its speed, and tuning PID parameters for reliable performance.
August 14, 2018 by Mahmoud Hamdy, Brightskies Technologies
In part 2 of this series, I'll continue the fundamental ADC noise discussion by covering how to measure ADC noise, noise specifications in ADC data sheets, and absolute versus relative noise parameters.
February 13, 2018 by Bryan Lizon, Texas Instruments
Digital power supplies are widely employed in high-end servers, storage, telecom brick modules, and more. For these applications, isolation is often required. This article discusses the digital isolation techniques with Analog Devices’ iCoupler products in digital power supply design.
August 01, 2017 by Jason Duan, Analog Devices
This article will briefly discuss isolation in the process control analog input module and the traditional approaches to achieving this. It then outlines an alternative high density, easy to design channel-to-channel isolation analog input module architecture.
March 14, 2017 by Van Yang, Analog Devices