All About Circuits

Latest Analog Articles and Videos

Categories

How to Design a Capacitive Sensor for Liquid Level Measurements

How to Design a Capacitive Sensor for Liquid Level Measurements

This article describes a non-contact liquid level sensor using fringing field capacitance with the AnalogPAK IC, using Math Core calibration for improved stability.


The Benefits and Limitations of Pre-Emphasis and De-Emphasis in FM Noise Reduction

The Benefits and Limitations of Pre-Emphasis and De-Emphasis in FM Noise Reduction

Pre-emphasis and de-emphasis boost noise performance in FM, but only up to a point—push the gain too far and you risk overmodulation.


Vishay EMIF-1S1P-481N EMI Filter Reference Design | Digital Datasheet

Vishay EMIF-1S1P-481N EMI Filter Reference Design | Digital Datasheet

Vishay EMIF-1S1P-481N EMI Filter Reference Design provides a flexible, ready-to-test platform for developing and optimizing single-phase, single-stage EMI filters. Watch and learn all about their features, specs, applications, and more!


new products Sep 19, 2026 by Mouser
Pre-Emphasis and De-Emphasis Filtering in FM Systems

Pre-Emphasis and De-Emphasis Filtering in FM Systems

Simple first-order pre-emphasis and de-emphasis filters can boost FM receiver SNR by more than 13 dB by exploiting the spectral differences between signal and noise.


FM Threshold-Extended Demodulators: Insights on FMFB and PLL-Based Designs

FM Threshold-Extended Demodulators: Insights on FMFB and PLL-Based Designs

Worked examples quantify just how much the FMFB loop shrinks noise bandwidth. We also show how the PLL demodulator offers a simpler alternative for reducing threshold.


The LM3914: Turning a Voltage Into a Row of Lights

The LM3914: Turning a Voltage Into a Row of Lights

National Semiconductor reduced the analog bar-graph display to a single IC, a handful of LEDs, and one resistor. The level meter was never the same.


News Sep 11, 2026 by Luke James
Sensibel’s MEMS Smart Optical Microphone Hits New Performance Peaks

Sensibel’s MEMS Smart Optical Microphone Hits New Performance Peaks

The new mic offers an 84-dBA signal-to-noise ratio and a 146-dB acoustic overload point—a 10-dB improvement over the industry standard.


News Sep 09, 2026 by Duane Benson
Evaluating SNR Performance of FMFB Demodulators at High CNR

Evaluating SNR Performance of FMFB Demodulators at High CNR

While feedback lowers the FM detection threshold, it offers no noise advantage over conventional receivers when the carrier power is strong. Discover why in this discussion and mathematical analysis.


Building a 5 V Single-Supply Electret Microphone Preamp

Building a 5 V Single-Supply Electret Microphone Preamp

This project brief describes how to build a compact, single-supply preamplifier module that converts the output of an electret microphone into a usable line-level audio signal.


Bourns Adds LTCC Bandpass Filters for 5G C-Band RF Front Ends

Bourns Adds LTCC Bandpass Filters for 5G C-Band RF Front Ends

The new devices provide compact C-band filtering options for 5G RF front-end designs from 3,300 MHz to 5,000 MHz.


News Sep 01, 2026 by Austin Futrell
A Peek Inside the Electronics on the Nancy Grace Roman Space Telescope

A Peek Inside the Electronics on the Nancy Grace Roman Space Telescope

The Nancy Grace Roman Space Telescope’s mirror may get the headlines, but its detector chips, photon-counting cameras, and downlink amplifier tell the electronics story.


News Aug 31, 2026 by Robert Martin
FM Demodulation with Feedback: Exploring Threshold Reduction Mechanisms

FM Demodulation with Feedback: Exploring Threshold Reduction Mechanisms

By closing a feedback loop around the demodulator, the FMFB architecture narrows the noise bandwidth and lowers the FM threshold, without improving SNR at high CNR.


Microchip Reveals One of Its Lowest Power Atomic Clocks Yet

Microchip Reveals One of Its Lowest Power Atomic Clocks Yet

Drawing less than 120 mW and tolerating 30 krad of total ionizing dose, the chip-scale atomic clock keeps LEO satellites synchronized when GNSS timing is unavailable.


News Aug 27, 2026 by Luke James
Build an Instrumentation Amplifier with Picoamp-Level Input Bias Current

Build an Instrumentation Amplifier with Picoamp-Level Input Bias Current

Discover how the LT1079 quad op-amp minimizes sensor loading in battery-powered designs. Active cancellation and an onboard bridge network ensure maximum precision for resistive sensors.


Exploring the Threshold Constraints of FM Demodulation Through Solved Examples

Exploring the Threshold Constraints of FM Demodulation Through Solved Examples

Working through examples shows how the threshold effect reshapes FM design choices. See how ignoring it can undershoot the required carrier power by over 5x for the same target SNR.


Rohm’s New Oscillation Device Paves Path to Terahertz Commercialization

Rohm’s New Oscillation Device Paves Path to Terahertz Commercialization

Rohm’s second-generation resonant tunneling diode oscillator reaches 40 µW maximum output in the same package as gen 1.


News Aug 21, 2026 by Jake Hertz
Nuvoton Teams up With Klippel To Reimagine Smart Audio Amplifiers

Nuvoton Teams up With Klippel To Reimagine Smart Audio Amplifiers

New chip weds advanced technology from Nuvoton and Klippel to create a high-performance audio solution for smart audio devices


News Aug 17, 2026 by Duane Benson
Introduction to the Threshold Effect in FM Systems

Introduction to the Threshold Effect in FM Systems

The standard FM SNR equation breaks down once the carrier-to-noise ratio drops below a critical threshold, revealing a hard limit on trading bandwidth for noise performance.


The TL072: A JFET Op Amp That Became the Default for Audio

The TL072: A JFET Op Amp That Became the Default for Audio

Texas Instruments combined JFET inputs with a bipolar output stage in 1977—and it slowly took over guitar pedals, synthesizers, and mixing desks.


News Aug 14, 2026 by Luke James
A 60 W Class-AB Audio Amplifier: A TDA7296-Based Single-Channel Power Amp

A 60 W Class-AB Audio Amplifier: A TDA7296-Based Single-Channel Power Amp

Learn how to construct a robust DMOS-based board featuring mute and standby controls. It easily drives 4 or 8 Ω loads for your next custom stereo or speaker project.