Latest Resistors Articles and Videos

Analyze RLC Components Using the Admittance Smith Chart and Examples

Learn about the admittance Smith chart to analyze a parallel connection of resistors, capacitors, and inductors, and see the circuit's behavior over the swept frequency range.

2 days ago by Dr. Steve Arar

Learn by Example—Using an Impedance Smith Chart

Learn how a series RLC circuit with arbitrary component values can be represented as a point on the Smith chart and how an impedance contour on the Smith chart can be used to describe the circuit's frequency response.

March 17, 2023 by Dr. Steve Arar

Investigating Lossless Transmission Line Phase Constant and Infinite Bandwidth

Learn how to derive the wave equations for a lossless transmission line and look at its infinite bandwidth and phase constant.

January 27, 2023 by Dr. Steve Arar

Memtransistor-based Collision Detection Scheme is Inspired by Insects

Researchers at Pennsylvania State University created an ultra-low power collision detection system inspired by insects such as the locust, which can detect potential crashes, even at night.

January 25, 2023 by Darshil Patel

RTD Signal Conditioning—4-Wire Configuration, Ratiometric Measurement, & Filtering

Learn about RTD (resistance temperature detector) signal conditioning through a four-wire configuration, ratiometric measurement, and input RC filters.

November 18, 2022 by Dr. Steve Arar

Ratiometric Resistance Measurement Basics Using an Analog to Digital Converter

Learn the basics of ratiometric resistance measurements in analog to digital (A/D) converters, how it's measured, and example uses in a digital multimeter (DMM), microprocessor, and various resistive sensors.

October 07, 2022 by Harry Trietley

Electronic Component Aging—the Aging Effects of Resistors and Op-amps

Learn about the aging behavior of resistors and amplifiers using temperature calculations and the Arrhenius equation to understand resistor drift, resistor stability, and op-amp drift.

August 28, 2022 by Dr. Steve Arar

Temperature Drift in Resistors and Op-amps—Flicker Noise and Signal Averaging

Learn about temperature drift in electronic circuits, namely in resistors and amplifiers. We'll also cover how the effect of flicker noise comes into play and how drift limits the effectiveness of signal averaging.

July 15, 2022 by Dr. Steve Arar

TDK NTCSP Automotive Chip NTC Thermistor | New Product Brief

This New Product Brief (NPB) is part of a video series highlighting the features, applications, and technical specs of newly-released products.

April 17, 2022 by Mouser Electronics

Three New Power Devices Cut Down Component Count and BOM

By reducing component counts, power system designs can achieve critical advantages such as lower costs and easier manufacturing. Three recently announced power solutions offer vivid examples of trend.

April 15, 2022 by Ikimi .O

Examining the Negative Resistance of a Quartz Crystal Oscillator

This article discusses how we can examine the oscillator circuit to make sure that it has sufficient “negative resistance” or “oscillation allowance”.

June 18, 2021 by Dr. Steve Arar

An Introduction to Switched-capacitor Circuits

In this series of articles, we’ll discuss one of the fundamental building blocks of analog IC design: the switched-capacitor circuit.

April 21, 2021 by Jake Hertz

TDK Sensor Shows How Capacitive MEMS and Low-power IoT Go Hand in Hand

TDK recently announced the so-called "lowest power waterproof MEMS barometric pressure sensor." Why did TDK choose capacitive MEMS as the go-to architecture for low power?

April 15, 2021 by Jake Hertz