This article looks at the safety standard that governs ADAS features and the challenge in designing power monitoring systems to comply with this standard while introducing an automotive power monitor that has been certified to meet this standard.
September 06, 2019 by Michael Jackson, Maxim Integrated
3GPP Release 16 holds the promise to make high precision location services cheaper and more reliable. Exploiting new signal properties in combination with a variety of non-cellular technologies could enable forms of hybrid positioning.
April 02, 2019 by Sylvia Lu, u-blox
This article looks at a solution to add additional USB charging ports to a vehicle using a single chip containing all the necessary parts and delivers 5V to the device.
July 10, 2018 by Nazzareno Rossetti, Maxim Integrated
Quad flat no-lead and discrete (or dual) flat no-lead packages provide a welcome increase in component density on a PCB area by eliminating leads. However, the solder connection quality cannot be tested by automated optical inspection. This article explores solutions to this often costly problem.
May 31, 2018 by Hans-Jürgen Funke, Nexperia
SoCs with programmable logic are an essential element of real-time embedded vision systems. Designers can capitalize on the power and efficiency of Xilinx's Zynq Ultrascale+ MPSoC devices to implement their designs using Avnet's Embedded Vision Kits and the Xilinx reVISION stack.
May 18, 2018 by Xilinx
This article describes a methodology that automates set up, constraints, and results analysis as designs move from static CDC analysis to formal verification to simulation and avoid manual scripting efforts, thus reducing setup effort and errors.
one day ago by Kurt Takara, Mentor
This article looks at the differences between crystal resonators and oscillators and presents examples that show when choosing crystals over oscillators could increase the total cost of a design.
November 05, 2019 by Bruce Potvin, SiTime
In this article, we’ll first look at the basics of representing a digital image. Then, we’ll discuss some simple operations that allow us to adjust the brightness and contrast of an image. Finally, we’ll briefly look at the circuit implementation of these operations.
October 31, 2019 by Steve Arar
