This 12-part “Resolving the Signal” series aims to provide a comprehensive understanding of noise in delta-sigma ADCs. In part 1 of this series, I’ll focus on ADC noise fundamentals.
January 23, 2018 by Bryan Lizon, Texas Instruments
Connected industrial machines can sense a wide array of information used to make key decisions within the Industrial Internet of Things (IIoT). A sensor within an edge node can be spatially far removed from any data aggregation point. It must connect through a gateway that links edge data with a network.
January 09, 2018 by Ian Beavers, Analog Devices
Part 1 of this two-part series discusses the key parameters and features a designer needs to be aware of and how they relate to inclination and stabilization applications, thus helping the designer choose the most suitable accelerometer.
December 12, 2017 by Chris Murphy, Analog Devices
This article describes the state of the semiconductor technology that is enabling new developments with shorter gate length GaAs and GaN transistors, circuit design considerations to achieve optimum performance, and examples of both GaAs and GaN wideband power amplifiers (PAs) that demonstrate today’s technology.
November 14, 2017 by Keith Benson, Analog Devices
Integrated RF agile transceivers are not only widely employed in software-defined radio (SDR) architectures in cellular telephone base stations, such as multiservice distributed access system (MDAS) and small cell, but also for wireless HD video transmission for industrial, commercial, and military applications, such as unmanned aerial vehicles (UAVs).
November 07, 2017 by Wei Zhou, Analog Devices
The next step of wide-area wireless connection is to bring the power of wireless to machine type communications (MTC). This will drive a revolution in services that will span sectors as diverse as manufacturing, city management, transportation, and energy.
October 17, 2017 by Emmanuel Gresset, CEVA
The industrial Internet of Things (IoT) encompasses the broad transformation underway that will make pervasive sensing across connected machines not just a competitive advantage, but an essential fundamental service. The industrial IoT starts with the edge node, which is the sensing and measurement entry point of interest.
September 12, 2017 by Ian Beavers, Analog Devices
Digital power supplies are widely employed in high-end servers, storage, telecom brick modules, and more. For these applications, isolation is often required. This article discusses the digital isolation techniques with Analog Devices’ iCoupler products in digital power supply design.
August 01, 2017 by Jason Duan, Analog Devices
With the introduction of a new set of requirements by the US Department of Energy that became law in February 2016, it has become mandatory for manufacturers to improve the efficiency of old designs to meet DoE Level VI in order to sell them to the US market.
July 11, 2017 by Zhihong Yu, Monolithic Power Systems
High precision op amps enable system designers to create circuits that condition signals (amplify, filter, and buffer) while maintaining the precision of the original signal. The precision of the total system depends on maintaining the precision of the signal path.
June 20, 2017 by Daniel Burton, Analog Devices